PDA

View Full Version : New Logic piece- Set-Reset Logic, With emmiters



Kern
11-30-2009, 08:12 PM
I made this a while ago while trying make a lift that would go up when grabbed and down when activated by a proxy, Logic Pack came out, and i realised, i had made my own Set-Reset Logic piece, I asked RTM and he seemed interested. So i thought others might be interested too, It involves Dissolve which may seem daunting (:cry:)

How it works
It works by the grab emitting a piece of dissolve with a mag key and a Mag key switch, this activates the piston which lifts the lift up; However, if you were to say, Fall off the lift, Then you activate a sensor switch which then activates another emitter which then dissolves the originally emitted piece, bringing the lift down, Simple.

What do you think?

Dante95
11-30-2009, 09:16 PM
I saw it live, it was cool. Good to make an elevator for sily people that fall down XD
No, seriously, it was cool. I saw the emitter version too :P

piggabling
12-01-2009, 01:06 AM
Yeah that sounds a lot more simple and efficient than the big logic thing I made a few months ago, before my PS3 crashed and the hard drive was wiped. D:

My elevator control system contained a few pistons, emitters, and mag keys. It looked way more complex than it really was. It included a grab switch in the elevator that would make it go up or down, but only if it were to reach the top would it be able to change direction. It also had a grab switch on the ground that would call the elevator back down. I made that back before I knew anything about logic and was so happy when it worked! :p

Your system is so much better, or so it seems...... :p