PDA

View Full Version : making a closing door



sjbluedog24
11-01-2008, 02:25 AM
o.k. so I want to have a big stone block the path after my Sackboy enters a door and i don't want it to open back up. How do I do it? Do i use a sensor switch?

BassDeluxe
11-01-2008, 05:44 AM
You would do it the same way you would make a door open. Put a block of dark matter above your door, which should be in the open position to start. Attach the two with a winch. Make another block of dark matter elsewhere, and dissolve material on top of it. Put a key on the dissolve and a key switch on the dark matter. make sure to invert the key switch. Now put a sensor switch or w/e where you want the door to close at. Rather than attaching that to the winch, though, attach it to the dissolve material, and attach the key switch to the winch. If you understood all of that, it should succeed in permanently closing the door.

sjbluedog24
11-01-2008, 11:34 AM
Hey, thanks, well ,actually I found out that i had an object that did that in my tools bag that I recieved from an online level. So I am good now.

RAINFIRE
11-01-2008, 05:05 PM
yeah just remember how to do this because after all you will end up using this a lot for your tricky contraptions and obsticles in your levels, i know i certaintly do