PDA

View Full Version : How to make a ride



burgerstupr
04-08-2013, 07:58 AM
OK so you design your ride first like a super loop or a rollercoaster! for a super loop if you have those roller coaster bends use them. build them around in circle good to get grid snap on. now build the thing thats going to be the coaster that goes around. its good to connect them with springs. once thats done set up your seats i recommend to use controllinators for this. next how many seats? the number of seats you have get an or gate and set it to the number of seats you have. next wire up the controllernators or grab sensors to the or gate. now makeing the wheels and moving system. make a line of flat materials on the back of the seats. make sure that you have a little bit at the bottom for the wheels. make the wheels with a material not a pre made one. now motor bolt them on. set them to 1500 speed. put a thruster at 65 perceny now whaterver!

EDIT:

i thought i was thruster then or gate

burgerstupr
02-07-2016, 02:15 AM
lol so old.

mdkd99
02-07-2016, 02:19 PM
But these posts are helpful.