PDA

View Full Version : Separate Layer Detection in Tag Sensors



koltonaugust
11-02-2014, 05:39 AM
Okay so in the beta, using the layer bit in the tag sensor was awful as setting it to 1 would check for one in front and one in back. What if there was a separate setting for front and back? I think it's a good idea but i could be alone...

Devious_Oatmeal
11-02-2014, 11:06 AM
Question. Did you stick the tag sensor on a thin piece of material, or a thick piece?

koltonaugust
11-02-2014, 08:56 PM
Thin and thick. I didn't notice a difference, was there one?

Devious_Oatmeal
11-03-2014, 02:36 AM
Thin and thick. I didn't notice a difference, was there one?

No clue. Was curious if there was one.

ramkibainu
11-03-2014, 05:25 AM
mmm... I think the tag sensor only works in thick layers if you set the same layer option.