I have a quick question that is probably simple but I can't figure it out for the life of me:
I have one controllinator on my Sackbot's default microchip set to receive and one controllinator on the hologram material set to follow my sackbot. There's a lot of logic all around but we'll just ignore that for now. My question is this: Is there a way to make your Sackbot not grab things? I realize this sounds simple but I've tried not attaching wires to the R1 input on the receiver, I've tried using "Not" switches and one-shot "Counter" switches but nothing seems to work. Any ideas?
Basically, I see it as this:
If I select the R1 output on the controllinator set to receive and then attach it to the "Not" switch, it is saying "When R1 is not pressed, the output of the "Not switch" will happen. I can't set this output to the R1 input because then when R1 is not pressed, the original control of R1, grabbing, will activate. What I need is to make it so the original control of R1 to not work, but I can't figure that out.

